Servo Motor Repair
Servo motors with position deviation, vibration, overheating or brake problems are assessed in our Beylikdüzü laboratory together with their mechanical, electrical and feedback systems. The repair scope is communicated in writing after diagnosis.
Real laboratory / field photo
Service overview
Servo motors with position deviation, vibration, overheating or brake problems are assessed in our Beylikdüzü laboratory together with their mechanical, electrical and feedback systems. The repair scope is communicated in writing after diagnosis.
We work independently of brand. Including the model and serial details in your request speeds up the assessment; if the model is unknown, a photo of the rating plate is sufficient.
Which symptoms call for an assessment?
- Position deviationThe axis does not hold its target or stops with an alarm.
- Vibration and noiseUnusual noise, resonance or shaking during operation.
- OverheatingThe housing is hotter than normal; thermal alarm.
- Brake problemThe brake does not hold or does not release; the axis drifts.
A symptom is not a diagnosis; the cause becomes clear during laboratory diagnosis.
Work performed
| Area | Description |
|---|---|
| Feedback (encoder / resolver) | Assessment of signal integrity, alignment and connections. |
| Bearings and bearing seats | Check of wear, play and noise sources; replacement where necessary. |
| Brake | Holding and release behaviour, coil and mechanical check. |
| Winding and rotor | Electrical measurements, insulation and mechanical integrity. |
Analysis and testing approach
After repair, feedback verification, electrical checks and an operational test permitted by the model are carried out. The test scope is determined by the device model and the repair performed; the same procedure is not assumed for every motor.
Quotation, approval and delivery process
Registration
We record the device details and symptoms and send you a reference number.
Analysis
The fault is diagnosed in the laboratory, so it is clear what has failed.
Quotation and approval
Scope and price are confirmed in writing; nothing is done without your approval.
Repair
The repair is carried out within the approved scope; you are informed of any deviation.
Testing and delivery
The device is tested under suitable conditions and returned with a short technical summary.
Preparing for shipment
Pack the motor with its original fasteners so that the shaft and connectors are protected. If available, note the alarm history and any previous repair information. Follow electrical and mechanical safety rules during removal; no instructions for hazardous dismantling are given here.
Frequently asked
It depends on the type of fault and the condition of parts. After diagnosis, you are given a timeframe in writing.
Devices are accepted by courier from anywhere in Türkiye. Follow the steps in the shipping preparation section.
Repairs are covered by warranty; the scope and conditions are stated in writing in the quotation.
Encoder and resolver problems are within the scope of assessment; the outcome becomes clear at diagnosis, depending on the condition of the device.